CCENT ICND1 Practice Exam 2

NTP is used for clock synchronization on routers. Clock Synchronization is important for? (Choose best two)

In a switch if the destination hardware address is known and present in the database, switch only sends the frame to the appropriate exit interface and not to all ports, this process is called ____________________

The below command is an example of which type of routing?
ip route 0.0.0.0 0.0.0.0 172.16.10.15

If we have an IP address 8.252.141.171/12 configured on the router interface, what will be the broadcast address used by the host on the LAN?

You configure two routers and when you issue command to check the interface status:
Router#sh int f0/2
FastEthernet0/2 is administratively down
How do you bring this interface up, which is the valid command?

_____________________ is used in switches for solution to loop avoidance.

______________ prevents a sending host on one side of the connection from overflowing the buffers in the receiving host

Which of these is not a feature of RIPv1 routing protocol?

The DOD (Department of Defense) Model’s Application or Process Layer corresponds to which Layer of OSI Model (Choose 3)

In OSPF, the Hello packets are address to which Multicast IP address?