CCIE Routing and Switching Practice Test 2 What is the main reason of defining static peers in EIGRP? Security requirements do not allow dynamic learning of neighbors Back-level peers require static definition for successful connection Both 1,2 None of the above You have noticed that some routers are stuck in Two-way state in OSPF. What is the cause of this issue? This is normal on OSPF broadcast network types Hello packets are not being received on these routers The network type is configured incorrectly on these routers None of the above Which of the following statement is true regarding BGP originator ID? The route reflector sets the originator ID to the router ID of the route reflector client that injects the route into the AS. The originator ID is set to match the cluster ID The route reflector always sets the originator ID to its own router ID None Which of the following statement(s) are true about Private Vlans? Only one isolated VLAN can be mapped to a primary VLAN Multiple community VLANs can be mapped to a primary VLAN Both 1,2 None What is VPLS? It can work over any transport that can forward IP packets It can carry a single VLAN per VPLS instance. It includes automatic detection of multihoming All of the above What will be the main purpose of EIGRP summary leaking? to allow overlapping summaries to exist on a single interface to allow a component of a summary to be advertised in addition to the summary Both 1,2 None Which of the following key is used to secure the control plane in GETVPN? TEK MEk KEK CEK Which of the following statement is true about an EPL? (Choose which applies) It allows for service multiplexing It has a high degree of transparency The EPL service is also referred to as E-line It is a point-to-point Ethernet connection between a pair of NNIs To which port you will configure STP portfast BPDU guard? Root ports Host ports Alternate port All ports Loading … Question 1 of 9
