CCIE Routing and Switching Practice Exam 2 What will be the result come out when you enter port-channel load-balance src-dst-ip on an Ether Channel link? Packets are distributed across the ports in the channel based on the source and destination IP addresses Packets are distributed across the access ports in the channel based first on the source IP address and then on the destination IP addresses Packets are distributed across the ports in the channel based on the source and destination MAC addresses None You are a IT support engineer in a company. Your task is to design a switching solution for your company. Which of the following statement describe trunking links is incorrect? (Select which applies) The trunk link belongs to a specific VLAN Multiple trunk links are used to connect multiple end user devices. A trunk link only supports native VLAN. Trunk links use 802.10 to identify a VLAN. All of the above Which of the following state of HSRP send hello messages? (Choose Three) Standby Learn Listen Speak Active Which of the following protocol allow you to use multiple gateways? GLBP VRRP HSRP Firewall Which of the following is the Cisco compatible extensions program? (Choose which applies) Security Routing and switching Vlans and DoS Anology and digital signal voice Mobility How can you configure inter-Vlan routing between multilayer switches? (Choose which applies) Configure dynamic routing protocol Configure access port with network address Configure SVI interfaces with IP address and subnet mask None Why would you prefer a local Vlan if you compare with end to end Vlan? Users are grouped into VLANs independent of physical location About Eighty percent of traffic on the network is destined for Internet sites Both 1,2 None of the above What is an IP telephony calls? It is a sum of bandwidth necessary for each major application, including voice, video, and data, should not exceed 80 percent of the total available bandwidth for every link It is used for Call control signaling uses Real-Time Transport Protocol packets that contain actual voice samples Both 1,2 None How can you enable globally port-based authentication on a switch? dot1x system-auth-control aaa port-auth enable switchport aaa-control enable radius port-control enable Which of the following are the features of implementing end to end Vlans? (Choose which applies) Users are grouped into VLANs independent of a physical location Resources are restricted to a single location. Each VLAN has a common set of security and resource requirements for all members End-to-end VLANs are easy to manage Loading … Question 1 of 10
